I've been struggling with squeezing anything bigger then an ac/5 into an 'urbie but to no avail. Totally agree with you on the dhs, and the xl 170...
My .02 c-bills: GRF-2N. Yes please. ECM medium that would indeed make a nice brawler. I'd probably drop the case and the erppc for more ammo and a...
Michael's the man! :wub:
After a lot of wasted c-bills (approx 2.5 mil according to smurfy) I came up with this brawler summoner. [MEDIA] It's very mobile due to all the jj...
Could be me being too greedy. I even had heat-issues with 8x cERMLAS and 4x cERMLAS...
Thanks for the heads-up and clarifications, guys! :wub:
Here's my impressions of the Clanmechs. Kitfox - Stock builds range from meh to craptastic. Starts to shine when played in a support role as ECM/AMS...
Yes, you are correct. I blame general tiredness and boredom at work. :rolleyes:
Another tidbit you might've picked up on these very forums. XL engines weigh a lot less, but takes up more slots and if you loose 3 slots taken up by...
^agreeed. I had better luck with my adder when i swapped the c-erppcs for c-erllas. Ppcs just run too bloody hot! That and the biggest targeting...
The kitfox sure isn't an IS light. Play it as a long range harasser/ecm&ams-support for your buddies and you'll do fine. I usually adopt the largest...
Built this one myself because I had difficulties coming up with a decent build for the NVA-S. Only two tons of ammo is very limiting and if you...
Built mine with the nva-s left arm omnipod and 3cermlas instead of the cermlas/cerslas mix. Slightly higher alpha and a bit more range. 5/5 /CX
Good initiative, Lan. I'm looking forward to reading the whole post. /CX
Separate names with a comma.
